Ldi Point Descriptions - Toshiba APOGEE FLN APG001Z Function Manual

4.3.1.

LDI Point Descriptions

Table 7
Point Point
Number Name
21 FWD.REV
23 STOP.RUN
25 EXT1.2 ACT
27 DRIVE READY
28 AT SETPOINT
33 HANDAUTO ACT Indicates whether the drive is in local (HAND) or remote (AUTO) control.
36 FLN LOC ACT
37 CTL SRC
38 FLN REF1 SRC
39 FLN REF2 SRC
70 DI 1 ACTUAL
71 DI 2 ACTUAL
72
(DI 3 ACTUAL)
73
DI 4 ACTUAL
74
DI 5 ACTUAL
75
DI 6 ACTUAL
76 DO 1 ACTUAL
77 DO 2 ACTUAL
78
DO 3 ACTUAL
79
DO 4 ACTUAL
80
DO 5 ACTUAL
81
DO 6 ACTUAL
86 OK.ALARM
93 OK.FAULT
Logical Digital Input (LDI)
Indicates the rotational direction of the motor, regardless of control source.
Indicates the run status of the drive, regardless of control source.
Indicates whether channel 1 or channel 2 is the active control source.
Indicates the drive is ready to accept a run command.
Indicates the drive has reached its commanded setpoint(f101､f102).
Indicates if the drive has been placed in "FLN LOCAL" mode by commanding
either point 68 (FLN LOC CTL) or point 69 (FLN LOC REF). Commanding
either of these points to FLN "steals" control from its normal source and places
in under FLN control.
Note that the HAND mode of the panel has priority over FLN local control.
Indicates if the FLN network is a source for control inputs.
Indicates if the FLN network is the source for setpoint 1(Pno.60).
Indicates if the FLN network is the source for setpoint 2(Pno.61).
Indicates the status of digital Input 1.
Depending on the status of the F terminal on the drive.
Indicates the status of digital Input 2.
Depending of the status of the R terminal on the drive.
Reserved (does not work).
Indicates the status of Digital Input 4 (1 = ON, 0 = OFF).
Depending on the status of the RES(f114) terminal on the drive.
Indicates the status of Digital Input 5 (1 = ON, 0 = OFF).
Depending on the status of the S1(f115) terminal on the drive.
Indicates the status of Digital Input 6 (1 = ON, 0 = OFF).
Depending on the status of the S2(f116) terminal on the drive.
Indicates the status of digital output 1.
Depending of the status of the FL(f132) terminal on the drive.
Indicates the status of digital output 2.
Depending of the status of the OUT1(f130) terminal of the drive.
Indicates the status of digital output 3 (1 = ON, 0 = OFF).
Depending of the status of the OUT2(f131) terminal on the drive.
Indicates the status of digital output 4 (1 = ON, 0 = OFF).
Depending of the status of the R2(f138) terminal on the drive.
Indicates the status of digital output 5 (1 = ON, 0 = OFF).
Depending of the status of the OUT5(f136) terminal on the drive.
Indicates the status of digital output 6 (1 = ON, 0 = OFF).
Depending of the status of the OUT6(f137) terminal on the drive.
Indicates the current alarm state of the drive.
Indicates the current fault state of the drive.
- 14 -
Point Descriptions
Description
E6581542①