Troubleshooting Guide - Guardian RH3200 Use & Care Instructions Manual

TROUBLE SHOOTING GUIDE
PROBLEM
SOLUTION
Power Plug: Unplug and then try again.
Water vapor and humidity
Power Failure: When the power is returned, try again.
are not produced.
Tank Installation: Make sure the tank is correctly attached.
The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
Excessive Water: Remove a certain amount of water from the
Air blows but water vapor
tank. Increase mist setting.
is not produced.
Detergent residue and/or oil ingredients from cosmetics, etc
may be in tank; wash out tank and try again.
The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
If you use hard water, replace with softer water.
The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
Humidity level is low.
The water in the unit is too cold: Replace with cool, but not cold
water. Damage on the ultrasonic disk: Contact Customer Service.
Poor maintenance or dirty water: Clean the product thoroughly,
The humidity has
and fill it with fresh water.
a bad smell.
Hard water may deposit a certain amount of dust. Dust in the air
White dust is forming on
nearby furniture. also settles because of added humidity in the room. Use distilled
water if this becomes a nuisance.
FLTDC20 filter is available at www.guardiantechnologies.com
or through customer service.
No or low water. Unplug unit and refill tank.
Unit has stopped working.
Check that the safety device triggered. To restart, unplug for
Unit shuts off unexpectedly
5 seconds, replug then press the power button.
or does not operate.
Call Customer Service.
Saturation of humidity. Lower mist control setting.
Water is accumulating
Unit not level and water is accumulating. Unplug and place on
outside of unit or area
level surface. Point spray away from objects. Raise unit on a
surrounding unit.
water-resistant level surface 2-3 feet off of floor.
Water remaining on bottom of tank. Wipe tank or tilt to drain
Water dripping
before transporting. Make sure both A and B tank caps are
when refilling.
secured tightly.
Unit must be placed on a flat, level, hard surface.
Increased noise level.
Make sure it is NOT placed on a soft or absorbent surface.
E-10