Qualification Of Personnel; Safety Label On The Device; Prohibition Of Unauthorized Conversions And Modifications - EM TEST coupling NX5 bs-3-480-16 Manual

EM TEST
Guard against risks of electrical shock during open cover checks by not touching any portion of the electrical
circuits. Even when power is off, capacitors may retain an electrical charge. Use safety glasses during open
cover checks to avoid personal injury by any sudden component failure.
Neither AMETEK CTS, or EM TEST (Switzerland) GmbH, nor any of the subsidiary sales organizations can
accept any responsibility for personnel, material or inconsequential injury, loss or damage that results from
improper use of the equipment and accessories.
WARNING
Only approved accessories, connectors, adapters, etc. are to be used to ensure safe operation.
2.4.

Qualification of personnel

The coupling NX series must be operated only by authorized and trained specialists.
2.5.

Safety label on the device

Please take note of the following explanations of the symbols used in order to achieve the optimum benefit from
this manual and to ensure safety during operation of the equipment.
CAUTION
WARNING
2.6.

Prohibition of unauthorized conversions and modifications

The user is not entitled to the device to perform its own modifications and adaptations. Modifying parts on the
generator by unauthorized persons will void the warranty of the device and the correct functioning cannot be
guaranteed.
Manual of operation
Personnel fitted with a heart pacemaker must neither operate
the instrument nor approach the test setup while a test is being
executed.
This symbol warns of a potential risk of shock hazard. The symbol on an instrument
shows that that it can source 1000 volt or more, including the combined effect of
normal and common mode voltages. Use standard safety precautions to avoid
personal contact with these voltages.
This symbol indicates where a caution is required. Refer to the operating instructions
located in the manual in order to protect against personal injury or damage the
equipment
The CAUTION symbol indicates a potential hazard. It calls attention to a procedure,
practice or condition which, if not followed, could possibly cause damage to equipment.
Such damage may invalidate the warranty. If a CAUTION is indicated, do not proceed
until its conditions are fully understood and met.
The WARNING symbol indicates a potential hazard. It calls attention to a procedure,
practice or condition which, if not followed, could possibly cause bodily injured or
death. If a WARNING is indicated, do not proceed until its conditions are fully
understood and met.
V 1.03
coupling NX
8 / 53