Hardware Installation - D-Link DCS-3110 Quick Install Manual

Hardware Installation

Hardware Installation

Connect the Ethernet Cable
Connect an Ethernet cable to the network cable
connector located on the Network Camera's back
panel and attach it to the network.
Connect Using Power-Over-Ethernet
Once you connect an Ethernet cable to your PoE
switch or adapter, the Power LED on the DCS-3110
will turn green to indicate a proper connection.
Attach the External Power Supply
Attach the external power supply to the DC power
input connector located on the Network Camera's
back panel (labeled DC 12V) and connect the other
end to an AC power outlet.
Note: The LED on the network camera will turn green, when you have a proper
connection. The light might go on and off and your computer may show an
intermittent loss of connectivity, this is normal until you have configured
your Network Camera.
5 D-Link DCS-3110 Quick Install Guide