Table of Contents
Advertisement
The programme is cancelled and a fault indicator light lights up
in the control panel
Problem
The fault indicator light
lights up, and
appear alternately in the
time display and the
buzzer sounds.
The fault indicator light
lights up, and
appear alternately in the
time display and the
buzzer sounds.
The fault indicator light
lights up, and
appear alternately in the
time display and the
buzzer sounds.
and alternately
appear in the time
display and the buzzer
sounds.
Cause and remedy
The water inlet is blocked or restricted.
Check whether the stopcock is opened properly.
Check whether the inlet hose is kinked.
Check whether the water pressure is too low.
The filter in the water inlet is blocked.
Clean the filter.
The water outlet is blocked or restricted.
The drain hose has been fixed too high.
Clean the drain filter and the drain pump.
The maximum delivery head is 1 m.
The water protection system has reacted.
Close the stopcock.
Call the Service Department.
There is a fault.
Disconnect the washing machine from the mains
electricity supply, either by switching off at the wall
socket and withdrawing the plug, or by
disconnecting the relevant fuse on the mains fuse
board.
Wait at least 2 minutes, before reconnecting the
washing machine to the mains electricity supply.
Then switch the washing machine on again.
Restart the programme.
If the fault message appears again, contact the
Service Department.
Problem solving guide
49
Hide quick links:
Advertisement
Table of Contents
