Table of Contents
Advertisement
FORM-ENG-0018 REV A 05-27-03
607 NW 27th Ave
PRODUCT GROUP
Ocala, FL 34475
Ph: 352-629-5020 or 1-800-533-3569
Fax : 352-629-2902 or 1-800-520-3473
PRODUCT
3.2.
Magnetic switches
The ITL40 has two magnetic switches (left and right). The switches are activated by touching a magnet to either side
of the display in the areas shown in picture below. The label has a small "o" to indicate the location of the magnetic
switch.
For best results the magnet should be positioned over the desired switch approximately 2 inches from the front of the
display, pushed directly to the front of the display, and then pulled back to the start position (do not using a swiping
motion).
The LEDs on the display will indicate which switch was activated for approximately half a second and then the display
will go blank (LEFT = left two columns of LEDs, RIGHT = right two columns of LEDs).
The maximum time between magnetic switch activations is two seconds. If longer than two seconds have passed
between activations the unit will resume normal operation and the password attempted will be cleared.
MANUAL P/N:118253
S U I T A B L E F O R E X T E R N A L D I S T R I B U T I O N
OPERATION MANUAL
ITL40
P/N
Intelli-Tank Level 40
LEFT (L) indication
118404-XX
RIGHT (R) indication
8 of 27
PAGE
DATE
6/12/2019
REV
1.30
BY
AMS
P
: 6/12/19
RINTED
Advertisement
Table of Contents
