Quick Setup Guide
PLEASE READ END USER LICENSE
AGREEMENT BEFORE USING
Printed in U.S.A.
© 2010 Sony Corporation
Not the actual ratio
In the Box
Connect to a network
Internet TV (1)
When using wired connection, connect the TV and a router with
a LAN cable. When using wireless connection, you need to set
the Network Setup in the Initial Setup Wizard (on step 6).
Size AA batteries (2)
IR Blaster cable (1)
AC power cord (1)
Table-Top Stand (1)
Cable cover (1)
Screws (M4 x 10) (3)
Screws (M5 x 16) (3)
Quick Setup Guide (1)
or Wireless LAN
Reference Guide (1)
Warranty card (1)
End User License
If your connection method differs from that shown above, see "Help Guide" (http://esupport.sony.com/internettv/helpguide/). For details on "Help Guide," see the back side.
Connect the Cable/Satellite Box
Use one of the connection cables illustrated below. Then, place the IR Blaster near the
remote sensor of the Cable/Satellite Box.
Place the IR Blaster so that the infrared
transmitter points to the remote sensor of
the Cable/Satellite Box. For details on the
IR Blaster, see "Help Guide" on the back
audio cable or
When connecting the Cable/Satellite Box with an HDMI cable, you can use any HDMI jack on the TV.
For details of network connection with the Cable/Satellite Box,
see the operating instructions supplied with the Cable/Satellite Box.
You can control a Cable/Satellite Box via the Home Network depending on your Cable/Satellite TV provider.
For details, see "Help Guide" on the back side.
Connect other devices
Connect the AV Receiver and other devices to the TV if necessary.
IR Blaster cable
audio cable or
Blu-ray Disc player/DVD player/Game etc.
Connect to the power source
Plug the TV into the wall outlet.
Refer to the Table-Top Stand leaflet (supplied) for directions on how to
attach the AC power cord (except NSX-24GT1) and the cable cover.
Start Internet TV setup
Follow the directions of the Initial Setup Wizard displayed on the screen.
When you skip the Network Setup, only limited functions will be
available with the TV.
The screen may stay dark for several seconds after the Sony logo
disappears. Wait for a while until the Initial Setup Wizard is displayed.
It takes about 15 minutes to complete the Initial Setup.
* This illustration may differ from the actual display.