1.8
Check Power and Secure Cables
1. Remove the thumbscrew
2. Attach the power cord bracket with attached screw
tight.
3. Route the power cord over the back of the rail, into the cabinet side area.
4. Continue cabling. When all cabling is complete, connect power cord
controller unit.
5. To hold the power cord connector tightly in place, move the power cord bracket
over the rear of the power cord connector and tighten the attached screw
(see Figure 1-6).
DS15 Rackmount Installation Guide 1-7
, turning it clockwise, but not
to the power
.