Table of Contents
Advertisement
MATERIAL SUPPLIED
Remove all the components from the packets. Check that all the components are included.
• Hood assembled with motor, lamps and grease filters installed.
• Instructions for assembly and use
• 1 power supply cable
• 1 allen key
• 1 cable clamp
• 5 screws 3.5x9.5
• 4 screws 4.2x35
• 2 adjuster brackets
• 1 collar
INSTALLATION - PRELIMINARY ASSEMBLY INSTRUCTIONS
The hood is designed for installation and use in "Extractor version" or in "Filter version".
Extractor Version
Fumes are extracted and expelled to the outside through an exhaust pipe (not supplied) fixed to the hood exhaust pipe connector
Depending on the exhaust pipe purchased, provide for suitable fixing to the exhaust pipe connector
IMPORTANT: If already installed, remove the carbon filter/s.
Filter Version
Air is filtered through the carbon filter/s and recycled into the surrounding environment.
IMPORTANT: Check that air recirculation is ensured.
If the hood does not have the carbon filter/s, order one/them and fit before use.
Install the hood away from very dirty areas, windows, doors and heat sources.
The hood comes with all the materials necessary for installation on the majority of walls/ceilings. However, a qualified technician must ensure that the materials
are suitable according to the type of wall/ceiling.
INSTALLATION DIMENSIONS
Wall unit interior 760 mm min.
900 mm min.
Adjacent wall units
centre line
65 cm (gas or combi cookers)
50 cm (electric cookers)
This type of hood must be installed inside a wall unit or similar support.
260 mm
Adjacent wall units
GB12
Advertisement
Table of Contents
