Sony KDF-50E2000 Operating Instructions Manual page 17

[] MENU Press to display MENU to activate the M- , I*, ,_, II, and tl' buttons. Press again to exit MENU to
activate tile TV/VIDEO. - VOLUME + and- CHANNEL+ buttons.
[] =_=_ Press to confirm the selection or setting.
TV/VIDEO Press repeatedly to cycle through tile video equipment connected to the TV's video inputs.
[] 4,--,*, Press to adjust tile volume.
- VOLUME +
[] 41,-- tl_ Press to scan through channels. To scan quickly through channels, press and hold either - or +.
- CHANNEL +
[] TIMER LED When lit in orange, indicates one of the timers is set. When it is set, this LED will remain lit even if
the TV is turned off. For details, see page 72.
[] LAMP LED Flashes in red when the lamp for the light source has burned out. For details, see "Replacing the
Lamp" on page 76.
[] POWER Lights up in green when the TV is turned on. If the LED blinks in red continuously, this may
indicate the display unit needs servicing (see contacting Sony information on page 2). When the red
LED blinks only three times, the lamp door of the lamp unit or the lamp itself is not securely
attached (see page 78).
[] [] Infrared Receives IR signals from the remote control.
Receiver
Do not put anything near the sensor, as its function may be affected.
[] POWER Press to turn on and off the TV.
[]
Speaker
Outputs the audio signal.
'f_ The CHANNEL + button has a tactile dot. Use the tactile dot as a reference
when operating the TV.
_o
"4
17