General - Sony KDF-42E2000 Operating Instructions Manual

General

Problem
How to reset TV to factory
settings
How to restore Picture settings
to factory settings
How to restore Sound settings
to factory settings
Cannot cycle through the other
video equipment connected to
the TV
Cannot operate the setting
Lost password
TIMER LED on front panel is
lit
LAMP LED blinks in red
Digital cable box does not work ❏
Cannot record digital channels
to VCR
TV cabinet creaks
A slight creaking noise occurs
from the bottom part of the TV
The cooling fan is loud
"High Temperature Warning!"
message appears
The TV does not turn on
Possible Remedies
❏
Turn on the TV. While holding down the
POWER button on the TV. Release the POWER button then release the
The TV will turn itself off, then back on again with Initial Setup.
WARNING: This operation will clear all of your customized settings including
Parental Lock setting.
❏
Select Reset setting option while in the Picture setting (see page 59).
❏
Select Reset setting option while in the Sound setting (see page 62).
❏
Be sure the Label Video Inputs option is not set to Skip (see page 71).
❏
If a setting option appears in gray, this indicates that the setting option is not available.
❏
On the password screen (see page 68), enter the following master password: 4357.
The master password clears your previous password; it cannot be used to
temporarily unblock channels.
❏
When lit, indicates that the timer is set (see page 72). When the timer is set, this
LED will remain lit even when the TV is turned off.
❏
Replace the lamp (see page 76).
If you are connecting a VCR and digital cable box using a splitter, as described on
page 31, you must use a special bi-directional splitter that is designed to work with
your digital cable box. Contact your cable provider for details.
❏
Only analog channels can be recorded to your VCR.
❏
When the TV is in use, there is a natural rise in temperature, causing the cabinet to
expand or contract and may be accompanied by a slight creaking noise. This is not
a malfunction.
❏
Advanced Iris applies a mechanical iris system. When Advanced Iris is set, a
natural creaking noise occurs due to the basic structure of the optical unit. The
creaking sound is an inherent nature of this system and is not a defect.
❏
If the TV is used at high altitudes and set to High, the cooling fan runs faster and
its sound becomes louder. If the TV is not used at high altitudes, set Cooling
Mode to Normal (see page 73).
❏
Make sure to remove dust from the ventilation slots on the rear and both sides of
the TV. In addition, make sure that there are no obstacles in front of the ventilation
slots. If the message still appears after the dust or obstacles are removed, the TV
may need servicing. Call your local Sony Service Center.
❏
The TV cools down its projection lamp when the power is turned off. It takes up to
two minutes for the picture to come back after the TV is turned on again. Wait for
a while until the picture comes back.
button on the remote control, press the
M
button.
M
(Continued)
83