Display And Program Modes - Toshiba TE-18-BP Quick Start Up Manual

Basic Installation and Operation Guide TE Series Digital Solid State Soft Starters 18 – 1250A
Display Modes
There are three modes of display: The Status Display Mode, the Program Mode, and the Fault Mode.
Status Display Mode (Default Display)
The Status Display Mode displays seven "screens" of information. Motor Currents (3 phases), Remaining
Thermal Capacity, Ground Current, Remaining Time on the Process Timer, and Time Base of the Time Clock
Controller. This is also the entry screen for going into the Program Mode.
Status mode:
[0000.] The initial display on power up is four digits and the decimal. This indicates the motor current for
Phase A of the motor.
[0000] Scroll UP to display four digits only (no decimal). This indicates the motor current for Phase B. While
viewing Phase B, press the UP arrow again to view Phase C current.
[G000] Scroll UP to display the "G". This shows the value of the current flowing to ground on the motor leads.
[H000] Scroll UP to display the "H". This indicates the value of the remaining thermal capacity percentage of
the motor (i.e. H070 = 70% remaining thermal capacity).
Program Mode
The starter must be STOPPED in order to enter the
Program Mode. Use the Program Mode to view or change
Function (Fn) settings. To enter the Program Mode, press
the [Fn] key once from the Status Screen described in
section 5.3.1 of the Advanced Installation, Operation
and Programming Manual. The first time you enter the
Program Mode after power has been cycled to the starter,
the initial function [F001] should be displayed with the
selected digit flashing. If the TE Series starter has been
programmed and power to the unit has not been cycled,
the readout will display the last function viewed or
changed. To change to a different function, use the arrow
keys.
Viewing Function Programming and Values
The programming of each individual Function can be
viewed without making changes (values can also be
viewed in the Run Mode however, no changes can be
made). Each Function is signified by the letter "F" in the
beginning of the data, the 4 digit value of the function
follows after pushing the [READ/ENTER] key
• [F001] "F" indicates the programmable Function.
• [0000] This is the present setting of the applicable
function.
This display may include decimals between digits depending on the function setting's range and incremental
steps. [F001] - "F" indicates the programmable Function.
[0000] - This is the present setting of the applicable function. This display may include decimals between digits
depending on the function setting's range and incremental steps.
Pressing the [Fn] key again will return to the Function display without making changes.
21 | P a g e
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com