Omnitronic WAMS-08BT MK2 User Manual page 23

5 Audio player
6 USB port
7 Reception indicator
8 Reception indicator
9 Level control
10 Level control
11 Mono inputs
12 Hi-Z level switch
13 Level controls
14 Stereo input
15 AUX input
16 Level control
17 Tone controls
18 Effect control
19 Master control
20 Charging indicator
21 Clip indicator
22 Power indicator
23 Power on/off
24 Power input
25 Fuse holder
MP3 player with built-in Bluetooth receiver and 5 operating buttons.
[MODE]: For switching between USB, SD and Bluetooth operation.
[ /VOL-] / [ /VOL+]: Short actuation: for title or folder selection. / Long
actuation: for volume adjustment.
[REPEAT]: for selecting random play and repeat functions.
[►II/FOLDER]: Short actuation: for switching between play and pause. /
Long actuation: for switching over to folder selection mode.
Use this input to connect the optional USB dongle UWM-2HH for wireless
microphone operation. Alternatively, you can charge the batteries of
mobile devices up to max. 5V/1 A.
Lights when an audio signal from wireless microphone 1 is received.
Lights when an audio signal from wireless microphone 2 is received.
To mix the signal of the wireless microphone 1 to the master signal.
To mix the signal of the wireless microphone 2 to the master signal.
Channel 1 and 2 provide balanced mono inputs with combo connectors.
Use standard XLR or 6.3 mm cables to connect dynamic microphones to
these inputs. These inputs also accept high-impedance music
instruments such as electric guitars or electric bass guitars. Then adjust
the input level with the corresponding Hi-Z button.
Press this button to switch channel 1 or 2 to high-impedance instrument
level. When the button is released the corresponding input is switched to
microphone level.
To mix the microphone signal of channel 1 and 2 to the master signal.
Unblanced stereo RCA input for channel 3. Use a standard stereo RCA
cable to connect a line-level device (e.g. CD player) to this input.
3.5 mm jack for connecting portable audio units with line level (e.g. MP3
player) to channel 3.
This control determines the level of channel 3 and the audio player.
Therefore, do use the inputs in channel 3 during audio player operation.
Otherwise, both audio sources will be reproduced at the same time.
2-band tone control for the master signal (BASS = low frequencies,
TREBLE = high frequencies).
Adjusts the intensity of the internal reverb effect for the microphone
inputs of channel 1 and 2.
Adjusts the overall volume.
This indicator lights red when the battery is being charged. It lights green
when the battery is fully charged and during mains operation.
The PEAK LED lights if the internal power amplifier section is
overloaded. Reduce the volume of the signal sources accordingly.
This indicator lights green when the PA system is powered on. If it lights
red, the battery should be charged soon.
Switches the PA system on/off.
Used to plug in the supplied power cord.
Only replace the fuse when the device is disconnected from mains. Only
use fuses of the same rating and power.
23 • EN