Setting Up
Attaching the Table-Top
Stand
1
Refer to the supplied Table-Top Stand
leaflet for proper attachment for some
TV models.
2
Place the TV set on the Table-Top
Stand.
3
Fix the TV to the Table-Top Stand
according to the arrow marks
guide the screw holes using the
supplied screws.
~
• If using an electric screwdriver, set the tightening
torque at approximately 15 kgf·cm {1.5 N·m}.
4
GB
Adjusting the viewing angle of
the TV (HX703 and NX503
models only)
This TV can be adjusted within the angles
shown below.
1
that
Remove screw as
shown.
2
Lift up and tilt.
~
• To return to 0°, reverse the above procedure.
0º
4
Install screw into
the top screw hole
of the Table-Top
Stand.
3
Slide in.
6º