Table of Contents
Advertisement
Condition
Changes on the server are not
being applied or displayed
content differs from content
on the server.
Photo, music and/or video
files do not appear or icons are
not displayed.
The TV cannot be found from
renderer-compatible device
(the controller).
Only a few icons appear under
the "Network" in the Home
Menu.
You have been using
registered Widgets, but now
some contents won't appear
on the Widgets.
General
Auto Setup (freesat) is
stopped before it is completed.
The TV's power cannot be
turned on.
Some programmes cannot be
tuned.
24
GB
Explanation/Solution
• Sometimes changes are not applied to displays on the TV even though
content has been added and/or deleted on the server. If this happens, go
back up one level and try opening the folder or server again.
Preliminary Check
• Check that the connected device supports DLNA.
• Operations are not guaranteed for all servers. Also, operations differ
depending on the features of the server and the content in question.
• Turn the connected device on.
Check Connections
• Check that the LAN cable and/or mains lead/AC power cord of the
server has not become disconnected.
Check Settings
• Check that the connected device is registered under "Server Display
Settings".
• Check that the server is correctly configured.
• Check that the selected device is connected to the network and can be
accessed.
• If the "IP Address Settings" in "Network" under "Network Settings" is
set to "DHCP (DNS automatic)" or "DHCP (DNS manual)", it may take
some time to recognise devices if there is no DHCP server. Execute
"Server Diagnostics".
Check Connections
• Check that the LAN cable and/or mains lead/AC power cord of the
server has not become disconnected.
Check Settings
• Check if the "Renderer Function" is activated.
• Check that the connected device is registered under "Renderer Access
Control".
• This is normal when internet connection is not available.
You can use three pre-installed Widgets properly. To enjoy more
Widgets, please check that the LAN cable and/or mains lead/AC power
cord of the router/modem has not become disconnected. (*)
• Check that the LAN cable and/or mains lead/AC power cord of the
router/modem has not become disconnected. (*)
• There's a possibility that the Widget Provider's server is out of service.
Please try using the Widget later.
(*) Your router/modem must be properly set to connect to the internet in
advance. Please contact your Internet Service Provider for the router/
modem settings.
• Check connections and dish alignment. The dish needs to be pointing at
Astra 2 at 28.2° East, and Eurobird 1 at 28.5° East.
• If the problem persists, consult your freesat registered retailer or call
Freesat (UK) Ltd on 0844 881 6700 or visitwww.freesat.co.uk.
• Check if ENERGY SAVING SWITCH is on (page 10).
• Check the aerial or dish.
• The satellite cable might be short-circuited or there might be connection
problems of the cable. Please check the cable and connection and then
turn the TV Off with the Mains power On / Off switch, and turn it On
again.
• The frequency you entered is out of range. Please consult the received
satellite broadcasting company.
Advertisement
Table of Contents
