Running initial setup
Complete your cable connections
before proceeding with the Initial
Connect the TV to your nearest power
Check the ENERGY SAVING
SWITCH setting is on (z).
Press 1 (POWER) on the TV.
When you switch the TV on for the first
time, the Language menu appears on
• The TV image shown here may differ from your
TV but the operation of your TV remains the same
Follow the instructions on the screen.
• The ENERGY SAVING SWITCH must be on
(z) to set the clock and obtain program
information for the TV Guide.
• Home mode sets the TV to display the settings
optimized for home viewing (this setting is
ENERGY STAR compliant).
Select Continue to scan for available
channels and enable the TV Guide On
feature. If you receive
channels from a cable box or satellite
receiver and do not wish to use the
TV's built-in tuner, select Skip.
Selecting Skip will disable the TV
Guide On Screen feature, which is
only available when the TV's tuner is
• If you skip the channel scan while in the setup
menus, TV Guide will be disabled.
Detaching the Table-Top
Stand from the TV
Remove only the screws marked with
• Do not remove the Table-Top Stand for any
reason other than to install corresponding
accessories on the TV.
For KDL-60NX801, KDL-60/52/
46NX800 and KDL-46/40NX700
• The NX801/NX800/NX700 series models must
remove the stand rear cover prior to detaching the
• When installing the TV on a wall, remove the four
screws from the rear of the TV. (They are fastened
in the screw holes for wall mounting.) Be sure to
store the removed screws in a safe place, keeping
them away from children (except KDL-46/
• When attaching the Table-Top Stand again, be
sure to fasten the four screws (previously
removed) to the original holes on the rear of the
TV (except KDL-46/40NX700).
For KDL-55NX811, KDL-60/55/
46NX810, KDL-46/40NX711 and