Rear Panel - Sony XC-EU50 Technical Manual

Sony corporation ccd black-and-white video camera module xc-eu50/eu50ce
Hide thumbs Also See for XC-EU50:
Table of Contents

Advertisement

Rear Panel

1
VIDEO OUT/DC IN/SYNC (video output/DC power
input/sync signal I/O) connector (12-pin)
5
75Ω termination switch
Note
When you do switch settings, make sure the unit is off.
1 VIDEO OUT/DC IN/SYNC (video output/DC
power input/sync signal I/O) connector (12-pin)
Connect a CCXC-12P05N camera cable to this
connector for the +12V DC power supply and the
video signal output from the camera module. When a
sync signal generator is connected to this connector,
the camera module is synchronized with the external
sync signals (HD/VD signals).
2 Shutter speed/Mode setting DIP switch
Shutter speed (bits 1–4):
Set an appropriate shutter speed. (Factory setting:
OFF)
Potential accumulation mode (bit 5):
(Factory setting: FRAME)
Restart reset/External trigger shutter mode switch
(bits 6–8):
(Factory setting: Normal)
γ compensation ON/OFF switch (bit 9):
Turn on this switch to enable the γ compensation.
(Factory setting: OFF)
GAIN switch (bit 0):
This switch selects MGC (manual adjustment) or
AGC (automatic adjustment). (Factory setting:
MGC)
2
Shutter speed/Mode setting DIP switch
3
Manual GAIN (M GAIN) control knob
4
HD/VD signal input/output switch
3 Manual GAIN (M GAIN) control knob
If you have selected MGC with the GAIN switch (DIP
switch 2), this knob adjusts the gain. (Factory setting:
twelve o'clock position)
Note
If you have selected FRAME using the Potential
accumulation mode (DIP switch 2), set this knob to
MAX. (This is due to requirement CCD.)
4 HD/VD signal input/output switch
Set the switch to INT to output HD/VD signals from
the camera module.
Set the switch to EXT to input HD/VD signals from an
external unit. (Factory setting: EXT)
5 75Ω termination switch
Turn this to OFF when not terminated. (Factory
setting: ON)
Overview
6

Advertisement

Table of Contents
loading

Table of Contents