Hookups And Settings; Hooking Up The Recorder; Step 1: Unpacking; Step 2: Connecting The Antenna Cable - Sony RDR-GXD455 Operating Instructions Manual

Hookups and Settings

Hooking Up the Recorder

Follow steps 1 to 7 to hook up and adjust the
settings of the recorder.
Notes
• Plug cords securely to prevent unwanted noise.
• See the instructions supplied with the components to be
connected.
• You cannot connect this recorder to a TV that does not
have a video input jack.
• Be sure to disconnect the power cord of each
component before connecting. Do not connect the
power cord until you reach "Connecting the Power
Cord" on page 26.

Step 1: Unpacking

Check that you have the following items:
• Audio/video cord
(phono plug × 3 y phono plug × 3) (1)
• Antenna cable (1)
• Remote commander (remote) (1)
• Size AA (R6) batteries (2)
Step 2: Connecting the
Antenna Cable
Select one of the following antenna hookups. Do
not connect the power cord until you reach
"Connecting the Power Cord" on page 26.
If you have
Cable box or satellite receiver with a
video/audio output
Cable box with an antenna output
only
Cable without cable box, or antenna
only (no cable TV)
Notes
• If your antenna is a flat cable (300-ohm twin lead
cable), use an external antenna connector (not
supplied) to connect the antenna to the recorder.
• If you have separate cables for VHF and UHF
antennas, use a UHF/VHF band mixer (not supplied) to
connect the antenna to the recorder.
Hookup
A (page 18)
B (page 19)
C (page 20)
,continued 17