Sony PDW-V1 Operation Manual page 88

When the unit is powered on
Message in time Display
data display
condition
MENU Ver.UP off
ILL. SETUP! off
Exchg batt! off
LOW BATT! off
BATT EMPTY! off
a) With respect to setting of basic menu item 016
When a disc is inserted
Message in time Display
data display
condition
Unknown FS! off
No FS! off
ILL. Disc! off
Salvage NG off
525/60 Clip limit
625/50 Clip limit
IMX50 Clip limit
IMX40 Clip
IMX30 Clip
DVCAM Clip
4CHx/24 Clip limit
8CHx16 Clip
88
8-3 Alarms
Description
a)
Setup menu settings were reset,
because this unit was upgraded.
Setup menu data is invalid, or data
recalled with the maintenance menu item
"SETUP MAINTENANCE" - "AUTO
BANK RECALL" is invalid.
NVRAM battery is exhausted.
Battery pack power is low.
Battery pack power is exhausted.
Description
a)
The loaded disc was formatted by an
unknown file system.
The file system cannot be detected.
An unsupported disc was inserted.
Recovery of disc contents (salvage)
failed.
A disc recorded in NTSC format was
inserted when this unit is in 625 line
mode (PAL system).
A disc recorded in PAL format was
inserted when this unit is in 525(U) or
525(J) line mode (NTSC system).
The recording format of the loaded disc
differs from the format specified with
basic menu item 031 "RECORDING
FORMAT."
The number of channels and quantizing
bits of the loaded disc differ from the
specifications of maintenance menu item
"AUDIO CONFIG" - "DATA LENGTH."
Action
Reset the setup menu items.
See 7-2-2 "Basic Menu Operations"
(page 69) and 7-3-2 "Extended Menu
Operatoins" (page 75) for information
about making setup menu settings.
Maintenance menu item "SETUP
MAINTENANCE" - "SAVE MENU
DATA/LOAD MENU DATA" (see page
80) can be used to temporarily back up
and restore the current menu settings.
Reset the items in the setup menu.
It is time to exchange the battery on the
board. Contact your Sony service
representative.
Exchange with a charged battery pack.
See 3-2-2 "Using a Battery Pack" (page
33) for more information about
exchanging battery packs.
Action
Eject or format the disc.
See 3-6-5 "Formatting a Disc" (page 37)
for more information about formatting.
Eject the disc.
See 3-6-7 "Using the Salvage Function"
(page 38).
Use a disc recorded with the PAL
system.
Use a disc recorded with the NTSC
system.
To record on the disc, change the setting
of basic menu item 031.
See 7-2-2 "Basic Menu Operations"
(page 69) about how to change this
setting.
To record on the disc, change the setting
of maintenance menu item "AUDIO
CONFIG" - "DATA LENGTH."
See 7-4-2 "Maintenance Menu
Operations" (page 81) about how to
change this setting.