Application Alarms - gefran ADV200 Instruction Manual

6 Application alarms

The application carries out a series of checks on itself while it is functioning. The information is stored in the
Word alarm mon (PAR 12052) parameter.
The table shows the application-specific alarms:
APPLICATION
APPLICATION
ALARM CAUSE
ALARM CAUSE
BIT NUMBER [HEX]
0 0x0001
1 0x0002
2 0x0004
3 0x0008
4 0x0010
5 0x0020
6 0x0040
7 0x0080
8 0x0100
9 0x0200
The alarms indicated as "Signalled" are not generating any direct action on the drive. The PLC will
decide on what action to take.
Flying Shear for Roll Forming machines – Instruction manual
DESCRIPTION
Consistency
Cut
commands and blade position.
Alarm during the automated cycle.
Auto
Cutting does not meet the required
Cut length
tolerances.
Trolley exceeds minimum position.
Pos min
Pos max Trolley exceeds maximum position.
Trolley movement not synchronised with
Sync
the line.
Fast Stop Fast Stop commands active.
The length of the material (in progress)
Pos line inside the machine is excessive and will
not allow the cut.
check between
Not used
Not used
ACTION
cut
Signalled
Signalled
Signalled
Signalled
Signalled
Signalled
Stop during ramp
Stop during ramp
Pag. 29 / 29