gefran ADV200 Instruction Manual page 14

Suppose we have a cutting system with these specifications:
• The carriage advances 36 mm per motor revolution.
The encoder on the carriage motor has 1024 ppr.
•
• The advancement of the metric wheel on the material is 314 mm.
In this case, an encoder with 8192 ppr is suitable.
4.2.3.2 Configuration with 2 Encoders
Enter the encoder data in the ENCODER CONFIG. menu.
Table 3 shows the encoder configurations to be used with 2 encoders..
CONFIGURATION FOR ASYNCHRONOUS MOTOR WITH TWO ENCODERS
CONFIGURATION FOR SYNCHRONOUS MOTOR WITH TWO ENCODERS
Flying Shear for Roll Forming machines – Instruction manual
Encoder 1 (yellow) digital encoder on the metric wheel
Encoder 2 (green) digital encoder on the carriage motor
Encoder sel src = One
Encoder 1 (red) 5-track sin cos encoder on the carriage motor
Encoder 2 (yellow) digital encoder on the metric wheel
Encoder sel src = Null
Table 3: Configuration with 2 encoders
Pag. 14 / 29