Munters SY Series Instruction Manual
Munters SY Series Instruction Manual

Munters SY Series Instruction Manual

Circuit breaker switches

Advertisement

"SY"
Series
Circuit Breaker
Switches
Instruction Manual
"SY" Series
Circuit Breaker Switches
Models: SY2010 • SY2018 • SY2025 • SY2035 •
SY2050 • SY2070 • SY2080 • SY2100 • SY2150
© Munters Corporation, August 2017
1
QM1353r5

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SY Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Munters SY Series

  • Page 1 “SY” Series Circuit Breaker Switches Instruction Manual “SY” Series Circuit Breaker Switches Models: SY2010 • SY2018 • SY2025 • SY2035 • SY2050 • SY2070 • SY2080 • SY2100 • SY2150 © Munters Corporation, August 2017 QM1353r5...
  • Page 2 With the proper installation and maintenance it will provide many years of service. Please Note: To achieve maximum performance and insure long life from your Munters product it is essential that it be installed and maintained properly. Please read all instructions carefully before beginning installation. Warranty: For Warranty claims information see the “Warranty Claims and Return Policy”...
  • Page 3 Index Chapters Page 1. Unpacking the Equipment Equipment Dimensions 2. Installation Instructions Installation 3. Troubleshooting 4. Circuit Breaker Switch Selection Chart © Munters Corporation, August 2017 QM1353r5...
  • Page 4: Unpacking The Equipment

    Note: Three phase motors require motor starters with three phase overload protection. Contact your local electrician or electrical supply store. 1.2 Dimensions ¹ ₈ ⁷ ₆ ⁄ ” ⁄₁ ” FRONT VIEW SIDE VIEW © Munters Corporation, August 2017 QM1353r5...
  • Page 5: Installation Instructions

    (not provided). See Figure 1. Step 2 Drill entrance hole(s) in bottom of the enclosure for wiring. Use watertight connectors or PVC conduit to seal all wiring entrances. Watertight connectors may be ordered from Munters as follows: Used Round Mounting CAT.
  • Page 6 To Load Control & 250VAC Max. Line 1 Line 2 Note: O.L. Overload Information in parenthesis refers to 120VAC control. Connecting 120VAC neutral through L2 as shown Neutral will allow indicating light to operate. Ground © Munters Corporation, August 2017 QM1353r5...
  • Page 7: Troubleshooting

    Panel circuit breaker has Reset breaker will not run tripped Thermostat or control is not Adjust temperature set point calling for fan to be on Defective wiring to SY Replace wiring Breaker Defective SY Breaker Replace Breaker © Munters Corporation, August 2017 QM1353r5...
  • Page 8: Circuit Breaker Switch

    Circuit Breaker Switch Selection Chart Direct Drive Fan Motors - 60 Hz - Single Phase Used with Fan Motor HP Motor RPM 120 VAC SY Series/Fuses 240 VAC SY Series/Fuses 9”-10” 3250 SY2025 / 2.5A ---- 9”-10” 3250 ---- SY2018 / 1.8A 14”...
  • Page 9: Munters Corporation, August

    This page left blank intentionally © Munters Corporation, August 2017 QM1353r5...
  • Page 10 SY Circuit Breaker Switch is developed and produced by Munters Corporation, Lansing, Michigan U.S.A. 1-800-227-2376 Munters Europe AB, Isafjordsgatan 1, P.O. Box 1150, SE-164 26 Kista, Sweden. Phone +46 08 626 63 00, Fax +46 8 754 56 66. Munters Corporation 2691 Ena Drive, MI 48917 U.S.A. Phone +1 800-227-2376, Fax +1 517-676-7078 www.munters.us...

Table of Contents