Table of Contents
Advertisement
1. Select Layer B, and click VGA1 in PRE area, the [VGA1] light is on.
2. Select Layer A, and click DVI3 in PRE area, the [DVI3] light is on.
3. Select Layer C, and click CV1 in PRE area, the [CV1] light is on.
Then the VGA1, DVI3 and CV1 signals are displayed on the preview monitor display.
4. User can do the scale for any layer, the layer only changed on preview output, but not changed on program
output.
Preset
After setting, the layers on the preview output, we do not need to switching to the program output. Push the
[Save] button, the button light is on, and some of the buttons 0~12 in PRE area are on, and some flash. The
buttons on can be saved, and flash will be overwrite. Select the location that need to save , for example, button
1, OLED shows as follows.
Load
User can load the saved settings by pushing the [Load] button. For example, push button 1, the SAVE 1 will
display on preview monitor, then touch [TAKE] button to switch it to the program display after confirmation.
Address：S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen, Fujian Province, P.R.C
SAVE TO USER CONFIG MODE 1
SAVE IS SUCCESSFUL
7
Tel: 00865925771197
Email: sales@rgblink.com
Fax: 00865925771202
http://www.rgblink.cn
Advertisement
Table of Contents
