Minimum Pc Requirements; Pack Contents; Preparing The Base Station - Siemens Gigaset M34 USB User Manual

M34 fuer USA LBA / USA EN / A31008-M403-R101-3-7619 / Installieren.fm / 27.04.2006

Minimum PC requirements

Hardware
u
IBM AT-compatible Pentium III with 500 MHz processor speed
u
128 MB RAM main memory
u
20 MB free hard disk memory
u
1 free USB port
u
1 CD-ROM drive or 1 DVD drive
Software
u
Operating system
Windows 2000 (Service pack 4) or Windows XP.
Have the installation CD for your Windows operating system to hand. During the
installation of the Gigaset M34 software, the Setup Wizard checks the configuration
of your operating system. You may be prompted to install certain additional
Windows components.
u
User rights
It is necessary that you are logged in as a user with administration rights. Contact
your system administrator for details if necessary.

Pack contents

u
1 Gigaset M34 USB PC adapter
u
1 USB extension cable
u
1 CD-ROM containing software and comprehensive operating instructions
u
1 set of installation instructions

Preparing the base station

ì
Read the operating instructions for your base station.
ì
Connect your base station.
– Connect your base station to your phone line or PABX using the telephone cable.
– Connect the base station to the power supply using the mains adapter.
Your base station is now ready for use.
i
Now that your base station is ready for use, you can make external calls
and also take incoming calls.
It is not necessary to install the Gigaset M34 software to do this.
ì
You can check that your base station is working properly by dialling an
external telephone number.
ì
If you cannot make the call, check your phone line or the settings for
your PABX.
You will find a detailed description in the operating instructions for
your phone line or PABX.
Installing the software and device drivers
9