Reassembling the Computer
Installing the Drive Unit in Your Computer
Reinstall the floppy disk drive in the top drive bay.
Reinstall the floppy disk drive.
Reconnect the interface cables to the floppy disk drive.
Fasten the screws and front brackets as they were before.
Tuck the cables behind the drive so that they do not protrude
above the power supply module.
After checking the following points, slide the computer's cover
on and fasten the cover mounting screws at the back of the
• Are the connections between the drive unit and computer
• Are the jumpers set to the appropriate positions?
Remount the rear plastic panel and refer back to the proper
installation section if you answered "no" to either of the
Tuck the cables.