Sony DAV-DZ380W Operating Instructions Manual page 92

x Before pairing
Sound transmission is established by ID
(example).
Your room
This unit
ID A
ID A
S-AIR sub unit
x After pairing
Sound transmission is established between the
paired unit and S-AIR sub unit(s) only.
Your room
This unit
ID A
ID A
S-AIR sub unit
Pairing
To perform pairing
1
Place the S-AIR sub unit that you want
to pair near the unit.
Note
• Remove headphones from the surround
amplifier (if connected).
2
Match the IDs of the unit and the S-AIR
sub unit.
• To set the ID of the unit, see "To set the ID
of the unit" (page 89).
92
GB
Neighbor
ID A
S-AIR sub unit
Neighbor
No transmission
ID A
S-AIR sub unit
• To set the ID of the surround amplifier,
see "To set the ID of the surround
amplifier" (page 90).
• To set the ID of the S-AIR receiver, refer
to the operating instructions of the S-AIR
receiver.
3
Press SYSTEM MENU.
4
Press X/x repeatedly until "PAIRING"
appears in the front panel display, then
press or c.
5
After "START" appears in the front
panel display, press
The unit starts pairing and "SEARCH"
flashes in the front panel display.
To cancel pairing, press SYSTEM MENU.
6
Start pairing of the S-AIR sub unit.
x For the surround amplifier
Press POWER on the surround amplifier to
turn on the surround amplifier and press
PAIRING on the rear panel of the surround
amplifier.
The PAIRING indicator of the surround
amplifier flashes red when pairing starts.
When sound transmission is established,
the PAIRING indicator of the surround
amplifier turns red and "PAIRING" and
"COMPLETE" appear alternately in the
front panel display.
Tip
• To press PAIRING on the rear panel of the
surround amplifier, a slim instrument, such as a
paper clip, can be used.
x For the S-AIR receiver
Refer to the operating instructions of the
S-AIR receiver.
When sound transmission is established,
"PAIRING" and "COMPLETE" appear
alternately in the front panel display.
Note
• Perform pairing within several minutes of Step
5. If you do not, "PAIRING" and
"INCOMPLETE" appear alternately in the front
panel display. To continue pairing, press
start again from Step 5. To cancel pairing, press
SYSTEM MENU.
7
Press SYSTEM MENU.
The system menu turns off.
.
and