Step 3: Setting Up The Wireless System - Sony DAV-DZ380W Operating Instructions Manual
Sony dvd player user manual
Hide thumbs
Also See for DAV-DZ380W:
- Safety information manual (24 pages) ,
- Quick setup manual (2 pages) ,
- Quick setup manual (2 pages)
Table of Contents
Advertisement
Step 3: Setting up the
Wireless System
To use the wireless system, you need to set up
the surround amplifier. Before setting, make
sure that the wireless transceivers are inserted
into the unit and the surround amplifier correctly
(page 32).
This wireless system is called “S-AIR.” For
details of the S-AIR function, see “Using an
S-AIR Product” (page 89).
"/1
POWER / ON LINE
Indicator
S-AIR ID switch
POWER
10
EZW-RT
POWER
S-AIR ID
SPEAKER
A
POWER/ON LINE
B
C
L
PAIRING
PHONES
SURROUND SELECTOR
R
SURROUND
SURROUND
BACK
PHONES jack
SURROUND
SELECTOR switch
The unit transmits sound to the surround
amplifier that is connected to the surround
speakers. To establish sound transmission,
perform the following Steps.
1
Press "/1 on the unit.
The system turns on.
2
Set the SURROUND SELECTOR switch
of the surround amplifier to
SURROUND.
3
Set the S-AIR ID switch of the surround
amplifier to A.
4
Press POWER on the surround
amplifier.
The POWER / ON LINE indicator turns
green. If it doesn’t, check the transmission
status as follows.
To check the transmission status
You can check the status of sound transmission
between the unit and surround amplifier by
observing the POWER / ON LINE indicator of
the surround amplifier.
POWER / ON LINE
Status
indicator
Turns green.
Sound transmission is
established.
Flashes green.
Sound transmission is not
established.
Turns red.
The surround amplifier does
not output sound.
Turns off.
The surround amplifier turns
off or its protection is active.
For details of the surround amplifier, see
“Surround amplifier operation” (page 114).
To enjoy sound by using
headphones
You can enjoy the system’s sound by connecting
the headphones to the PHONES jack on the
surround amplifier.
Note
• The volume of the unit may become minimum if you
turn off the surround amplifier while the headphones
are connected to the surround amplifier, or radio
reception is poor. In this case, “HP NO LINK” and
“VOLUME MIN” appear alternately in the front
panel display. Check radio reception, and set the
volume again.
When you use multiple S-AIR
products
See “Establishing sound transmission between
the unit and S-AIR sub unit (ID setting)”
(page 89).
Page 35
GB
Hide quick links:
Advertisement
Table of Contents
