Mounting The Dlt-V72 At The Deployment Location - Advantech-DLoG DLT-V72 Series Operating Instructions Manual

NOTICE: Physical damage
Damage and scratching of the touchscreen without transport protective film.
The front display of the DLT-V72 is protected during transport by a transparent film. This film
should remain on the front display during assembly to avoid damage to the front display surface.
Only remove the film after all of the installation work has been completed.

11.2.

Mounting the DLT-V72 at the deployment location

Stationary or on vehicles
Risk of injury and damage due to improper deployment location.
Observe the intended use of the DLT-V72, e.g. not in potentially explosive areas, not in life-

supporting facilities.
Ensure that the deployment location of the DLT-V72 complies with the permissible

environmental conditions.
Risk of accident on vehicles due to unstable attachment of the DLT-V72.
When installing the DLT-V72, make sure that if the bracket breaks (e.g. because of a stress

fracture) no one will be injured.
Alternatively please put appropriate safety measures in place (e.g. install a security cable in

addition to the mounting bracket).
Radio wave emission in the vicinity of persons.
To ensure that the limits set for exposure to radio waves are not exceeded:
 Install the DLT-V72 so that persons maintain a minimum distance of 20 to 50 cm to the
antenna.
96 / 140
WARNING
Mechanical installation
DLT-V72 Operating Instructions V2.50 Preliminary