Editing A Program; Choosing The Effects - Sony DPS-V55M Operating Instructions Manual

Editing a Program

Choosing the Effects

Use the following operations to choose the effect(s) to be used in your program. You can choose up to two effect blocks
(when using 2ch (10~36) or Mono-Pair (37~45) effects). When using a 4ch effect (01~09), you may choose only one effect.
(See page 8 for details).
1
Press Fx TYPE (SEARCH) to display the type
screen.
F x T y p e : T y p e
F x A : 1 1
2
Turn the rotary encoder to select the
effect (01~45) for FxA.
The numbers (01~45) correspond to the effects printed
on the front panel to the left of the display.
F x T y p e : T y p e
F x A : 4 5
When you select a 4ch effect (numbers 01~09), press
EXIT to return to play mode and skip the following
steps.
3
Press EDIT PARAMETER / twice to move
the cursor to FxB.
Note: this is not possible if you select a 4ch effect
(01~09) in the previous step.
F x T y p e : T y p e
F x A : 4 5 / F x B :
Effect algorithms
/ F x B : 1 2
/ F x B : 1 2
1 2
FxTYPE
Display
(SEARCH)
EDIT PARAMETER EXIT
? /
4
Turn the rotary encoder to select an effect
(10~45) for FxB.
The numbers (10~45) correspond to the effects printed
on the front panel.
F x T y p e : T y p e
F x A : 4 5 / F x B :
5
Press EXIT to return to play mode.
To change the structure type before returning to the
play mode, press EDIT PARAMETER ? to switch to
the structure parameter, then proceed from step 3 of
"Choosing the Structure".
Rotary encoder
3 0
13
GB