Video Mode Settings; Starting/Stopping Video Transfer (Continuousshot); Oneshot And Multishot - Sony XCD-SX910CR, XCD-SX710CR, XCD-SX910UV, XCD-SX910, XCD-SX710 Technical Manual

Digital video camera module
Hide thumbs Also See for XCD-SX910CR, XCD-SX710CR, XCD-SX910UV, XCD-SX910, XCD-SX710:
Table of Contents

Advertisement

Video Mode Settings

Select the video mode you want to use from the tables,
and make the required settings. As examples, the
register settings for Format2, Mode2, and a frame rate
of 15 fps for the XCD-SX910CR/SX910UV/SX910,
and Format1, Mode5, and a frame rate of 30 fps, for
the XCD-X710CR/X710, are shown.
In addition, an isochronous transfer speed of
400 Mbps, and isochronous channel 0 are used in these
examples. Normally, set the isochronous transfer speed
to 400 Mbps.
When multiple cameras are used simultaneously, set
different isochronous channels for each one.
Data
Address
XCD-SX910CR/SX910UV/SX910 XCD-X710CR/X710
F0F00600h
60000000h
80000000h
(FrameRate)
F0F00604h
40000000h
A0000000h
(VideoMode)
F0F00608h
40000000h
20000000h
(VideoFormat)
F0F0060ch
02000000h
02000000h
(IsoChannel/
IsoSpeed)
Starting/Stopping
Video Transfer
(ContinuousShot)
In the device driver, after the preparations for
receiving isochronous data are made, video transfer
starts when the following commands are issued.
Address
Data
F0F00614h
80000000h
When the following command is issued, video transfer
stops.
Address
Data
F0F00614h
00000000h
XCD-SX910UV
XCD-SX910/X710
Control

OneShot and MultiShot

This camera supports both OneShot and MultiShot
commands. With a OneShot command, after outputting
a just one single-frame image, the camera enters an
“idling” state. With a MultiShot command, the camera
enters the “idling” state after outputting exactly the
specified number of images.
OneShot
Address
Data
F0F0061Ch
80000000h
MultiShot
Address
Data
F0F0061Ch
4000nnnnh
Nnnn indicates the number of frames to be output. You
can specify any number between 0001h ~ FFFFh
(1~65,535). If 0000h is specified, you can think of it as
1 being set instead.
Execution of ContinuousShot, OneShot, and MultiShot
are prioritized as follows. When a command with
higher priority is being executed, the one with the
lower priority is ignored.
ContinuousShot > OneShot > MultiShot
Page 20

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents