Inconsistent Positions - Honeywell Bendix/King KMD 550 Pilot's Manual Addendum

Multi-function display terrain function (egpws)

Hide thumbs Also See for Bendix/King KMD 550:

Table of Contents

INCONSISTENT POSITIONS

The EGPWS sensor may use a different position source than the GPS

sensor that is used by the KMD 550/850 for its map display. In the

unlikely event that these two positions are significantly different, the fol-

lowing message will be displayed:

Since the two positions are different, all overlays on the Terrain page will

be disabled. You should cross check your position since this may indi-

cate a problem with either your GPS receiver or your EGPWS unit. Once

the positions are back within tolerance of each other then overlays will be

re-enabled.

Rev 3 Jun/2004

KMD 550/850 Terrain Addendum

Table of Contents

Bendix/king kmd 850