Sony Cyber-shot DSC-T3 Operating Instructions Manual page 113

PictBridge compliant printer
Symptom
The connection cannot be
established.
You cannot print images.
Printing is canceled.
You cannot insert the date or print
images in the index mode.
The paper size you want to print on
does not appear.
"---- -- --" is printed on the date-
inserted part.
You cannot print with the current
paper size setting of the printer.
You cannot perform other operations
when printing is stopped.
Cause/Solution
• Consult with the printer manufacturer whether the printer is compliant with the PictBridge or not.
• Check that the printer is turned on and can connect with the camera.
• Set [USB Connect] to [PictBridge] on the Setup screen (page 126).
• Depending on the circumstances, the connection may not be established. Disconnect and connect the
USB cable again. If an error message is indicated on the printer, refer to the operating instructions
supplied with the printer.
• The camera is not connected to the printer. Check that the camera and the printer are properly
connected using the USB cable.
• Turn on the printer. For further information, refer to the operating instructions supplied with it.
• If you select [Exit] during printing, you may not print again depending on your printer. Disconnect
and connect the USB cable again. If you cannot print still, disconnect the USB cable, turn off and on
the printer, then connect the USB cable again.
• Movies cannot be printed.
• Images modified with a computer or images shot using other than this camera may not be able to be
printed.
• You disconnected the USB cable before the
• Consult with the printer manufacturer whether the printer provides date function or index print
function or not.
• The date may not be inserted in the index mode depending on the printer. Consult with the printer
manufacturer.
• Check with the printer manufacturer whether the printer supports the paper size you want to print on.
• The images that do not have the recording date data cannot be printed with the date inserted. Set
[Date] to [Off] and print the image.
• If the printer paper was changed to paper of a different size after the camera was connected to the
printer, disconnect and connect the USB cable again.
• The printing setting of the camera differs from the printer setting. Change the paper size setting of
the camera (pages 79 and 81) or change the printer setting.
• The printer is performing the printing stop processing, so wait for this processing to finish. (This
processing may take some time depending on the printer.)
(Not disconnect USB cable) mark disappears.
113