Adding A Print Order Mark; (Print): Printing Images Using A Printer - Sony DSC-H3 Cyber-shot&reg Handbook

Viewing menu
To select and protect images
1 Press MENU in single-image mode or in index mode.
2 Select [Protect] with v/V, and select [Multiple Images] with b/B, then press z.
In single-image mode:
3 Select the image you want to protect with b/B, then press z.
The is attached to the selected image.
4 Press b/B to display other images you want to protect, then press z.
5 Press MENU.
6 Select [OK] with v, then press z.
In index mode:
3 Select the image you want to protect with v/V/b/B, then press z.
The is attached to the selected image.
4 To protect other images, repeat step 3.
5 To select all the images in a folder, select the folder selection bar with b, then press z.
The is attached to the selected folder.
6 Press MENU.
7 Select [OK] with v, then press z.
To cancel the protection
Select the image for which you want to cancel protection, and unlock it by performing the
same procedure to protect it.
The (Protect) indicator disappears.
Note that the formatting erases all the data stored on the recording media, even if the images
•
are protected, and these images cannot be restored.
It may take some time to protect an image.
•

: Adding a Print order mark

Adds a print order mark (
See page 99.
(This Image)
(Multiple Images)

(Print): Printing images using a printer

Printing images shot with the camera.
See page 96.
For details on the operation 1 page 39
) to the image you want to print.
Attaches a DPOF mark to the image being selected now. Clears
the DPOF mark when the selected image has a DPOF mark.
Selects images and attaches DPOF marks to them. Clears DPOF
marks already attached.
59