Adjusting Hand And Day Indicator Alignment; Phone Finder; Configuring Watch Settings - Casio 5603 Operation Manual

Swapping Your World Time and Home
●
Time
1.
Y Tap the "OCEANUS Connected" icon.
2.
X Hold down (B) until the second hand
points to [C] twice.
This establishes a connection between
the watch and phone.
The second hand will point to [C] once
●
after about 0.5 seconds, and then a
second time after about 2.5 seconds.
3.
Y Perform the operation shown on the
phone screen to swap your Home Time
with your World Time.
For example, if your Home City is Tokyo
and the World Time City is New York, they
will be swapped as shown below.
Before swapping After swapping
Home City
(Tokyo)
30
World Time City
(New York)
World Time City
(Tokyo)
Note
Auto time adjustment does not work for
●
24 hours after swapping of the Home
Time and World Time.
Operation Guide 5603
Adjusting Hand and Day
Indicator Alignment
If the hands and/or date indicator are out of
alignment even though auto time adjustment
is being performed, use OCEANUS
Connected to adjust them.
1.
Y Tap the "OCEANUS Connected" icon.
2.
X Hold down (B) until the second hand
points to [C] twice.
This establishes a connection between
the watch and phone.
The second hand will point to [C] once
●
after about 0.5 seconds, and then a
second time after about 2.5 seconds.
3.
Y Perform the operation shown on the
phone screen to correct hand and day
Home City
indicator alignment.
(New York)

Phone Finder

30
You can use phone finder to trigger a tone on
the phone to make it easy to find. The tone is
forced to sound even if the phone is in vibrate
mode.
Important!
Do not use this function in areas where
●
phone call tones are restricted.
The tone sounds at a high volume. Do
●
not use this function when listening to
phone output over earphones.
1.
X If the watch is connected with a phone,
press any button to terminate the
connection.
Connected Disconnected
30 30
2.
X Hold down (B) until the second hand
points to [C] three times.
A connection will be established between
the watch and phone, and then the
phone's ringtone will sound.
It will take a few seconds before the
●
phone tone sounds.
3.
X Press any button to stop the tone.
You can press any watch button to stop
●
the phone tone, but only during the first
30 seconds after it starts to sound.

Configuring Watch Settings

You can use OCEANUS Connected to specify
the amount of time until the Bluetooth
connection is automatically terminated, and to
configure other settings.
1.
Y Tap the "OCEANUS Connected" icon.
2.
X Hold down (B) until the second hand
points to [C] twice.
This establishes a connection between
the watch and phone.
The second hand will point to [C] once
●
after about 0.5 seconds, and then a
second time after about 2.5 seconds.
3.
Y Select the setting you want to change
and then perform the operation shown on
the phone screen.
11