Mitsubishi Electric Q Series Programming Manual page 9

(6) Usage methods
Immediately turn OFF the power if smoke, abnormal sounds or odors are emitted from the Motion
controller, servo amplifier or servomotor.
Always execute a test operation before starting actual operations after the program or
parameters have been changed or after maintenance and inspection.
Do not attempt to disassemble and repair the units excluding a qualified technician whom our
company recognized.
Do not make any modifications to the unit.
Keep the effect or electromagnetic obstacles to a minimum by installing a noise filter or by using
wire shields, etc. Electromagnetic obstacles may affect the electronic devices used near the
Motion controller or servo amplifier.
When using the CE Mark-compliant equipment, refer to the "EMC Installation Guidelines" (data
number IB(NA)-67339) for the Motion controllers and refer to the corresponding EMC guideline
information for the servo amplifiers, inverters and other equipment.
Use the units with the following conditions.
Item
100 to 120VAC
Input power
(85 to 132VAC)
Input frequency
Tolerable
momentary
power failure
Q61P-A1 Q61P-A2
+10%
200 to 240VAC
-15%
(170 to 264VAC)
CAUTION
Conditions
Q61P Q62P
+10% +10%
100 to 240VAC
-15% -15%
(85 to 264VAC)
50/60Hz ±5%
20ms or less
A - 8
Q63P
+30%
24VDC 100 to 120VAC
-35%
200 to 240VAC
(15.6 to 31.2VDC)
(85 to 132VAC/
170 to 264VAC)
Q64P
+10%
/
-15%
+10%
-15%