Sony a (alpha) DSLR-A100 Operating Instructions Manual page 136

Others
Your camera does not work.
Use the type of battery pack you can use with this camera (page 142).
•
The battery level is low (The
•
"Read This First").
The lens gets fogged.
Moisture condensation has occurred. Turn off the camera and leave it for about an hour before
•
using it (page 147).
The message "Set date and time?" appears when you turn on the camera.
The camera has been left unused for sometime with a low battery or no battery pack. Change
•
the battery pack and set the date again (
lost every time the battery pack is changed, consult your Sony dealer or local authorized Sony
service facility.
The number of recordable images does not decrease or decreases two at a
time.
This is because the compression rate and the image size after compression change depending
•
on the image when you shoot with a JPEG image (page 83).
The setting is reset without the resetting operation.
The battery pack was removed when the POWER switch was set to ON. When removing the
•
battery pack, make sure the POWER switch is set to OFF and the access lamp is not
illuminated (
The camera does not work properly.
Turn off the camera. Remove the battery pack and insert it again. If an AC Adaptor/charger
•
(not supplied) is used, disconnect the power cord. If the camera is hot, allow it to cool down
before trying this corrective procedure.
The five bars of the Super SteadyShot scale flash.
The Super SteadyShot function does not work. You can continue to shoot but the Super
•
SteadyShot function will not work. Turn the camera off and on. If the Super SteadyShot scale
continues to flash, consult your Sony dealer or local authorized Sony service facility.
136
step 1 in "Read This First").
t
indicator appears). Charge the battery pack (
step 3 in "Read This First"). If the date setting is
t
step 1 in
t