Digital Vtrs Dsr-2000P - Sony 798 MHz to 822 MHz Brochure

Specifications
DIGITAL VTRs
DSR-2000P / DSR-1800P / DSR-1600P / DSR-1500AP
General
Power requirements
Power consumption (Max. )
Operating temperature
Storage temperature
Operating humidity
Storage humidity
Tape speed
Recording/Playback time
Fast forward/Rewind time
Search speed
still to ±60 times normal speed
Mass
Dimensions
(W x H x D, excluding projections)
Video Performance
Bandwidth Luminance 25 Hz to 5.0 MHz +1.0/-2.0 dB
(via analogue
component I/O)
Chrominance
S/N ratio (via analogue component I/O)
K-factor (K2T, KPB)
Y/C delay 0
Audio Performance
Frequency response
2 CH mode (48 kHz/16-bit)
4 CH mode (32 kHz/12-bit)
Dynamic range
Distortion (THD+N)
Video Signal Inputs
Analogue
Ref. Video Composite, 1.0 Vp-p, 75 Ω ,
(BNC x2, loop-through connection)
Video (BNC x2, loop-through connection)* 1
Component Y
(BNC x3) * 1
R-Y
B-Y
1
S-Video *
Digital
SDI * 2 * 3
3 4
SDTI (QSDI) (BNC x1) * *
i.LINK (DV In/Out) (6-pin x1)* 5 * 6 * 7
Audio Signal Inputs
Analogue
Audio * 1
Digital
AES/EBU * 2 * 3
Video Signal Outputs
Analogue
Ref. Video (BNC x1)
Video Video 1/2/3 (super) BNC x 3
Component (BNC x3)
S-Video
Digital
SDI * 2 * 3 * 8
SDTI (QSDI) * 3 * 4 * 9
i.LINK (DV In/Out) (6-pin x1) * 5 * 6 * 7
Audio Signal Outputs
Analogue
Audio
-6/0/+4 dBu (selectable by menu)
Monitor
-11 dBu, 47 kΩ , unbalanced
Headphone
(JM-60 headphone jack x1)
Digital
AES/EBU * 2 * 3 * 9
Time Code Input/Output
In (BNC x1)
Out (BNC x1)
Remote
RS-422A: D-sub 9-pin female x2
Video Control: D-sub 15-pin male x1
Control Panel: D-sub 15-pin female x1
Supplied Accessories
RCC-5G 9-pin Remote Control Cable
*1 The optional DSBK-1504 is required for the DSR-1500AP
*2 The optional DSBK1801 is required for the DSR-1800P
*3 The optional DSBK1501 is required for the DSR-1500AP
42
DSR-2000P
110 W
Standard size: 184 min. with PDV-184ME/184N/184MEM Mini size: 40 min. with PDVM-40ME/40N/40MEM
Standard size: Less than 3 min. with PDV-184ME/184N/184MEM Mini size: Less than 1 min. with PDVM-40ME/40N/40MEM
Shuttle mode:
Digital slow mode:
±1 times normal speed
18 kg (39 lb 10 oz)
427 x 175 x 496.5 mm
(16 7/8 x 7 x 19 5/8 inches)
5.75 MHz +0/-3.0 dB
(Typical measurement)
20 Hz to 20 kHz +0.5/-1.0 dB
20 Hz to 14.5 kHz +0.5/-1.0 dB
0.3 Vp-p, 75 Ω , sync negative
sync negative
Composite, 1.0 Vp-p, 75 Ω , sync negative
1.0 Vp-p, 75 Ω , sync negative
0.7 Vp-p, 75 Ω (100 %)
0.7 Vp-p, 75 Ω (100 %)
DIN 4-pin x 1
Y: 1.0 Vp-p, 75 Ω , sync negative
C: 0.3 Vp-p, 75 Ω (at burst level)
BNC x 2, active-through connection
Conforms to Serial Digital Interface (270 Mb/s), ITU-R BT.656
Conforms to SDTI (270 Mb/s), SMPTE 305M/322M
IEEE1394-based
XLR 3-pin female x4
-6/0/+4 dBu, 600 Ω on/off/ -6/-3/0/+4 dBu, 600 Ω on/off/
-60 dBu, high impedance -60 dBu, high impedance
BNC x 2
75 Ω , unbalanced
Y: 1.0 Vp-p, 75 Ω , sync negative
BNC x 3
Phono x 1
(-18 dBFS)
-∞to -13 dBu, 8 Ω ,
unbalanced (-18 dBFS)
AC Power Cord
Operating Instructions
*4 The optional DSBK1802 is required for the DSR-1800P
*5 The optional DSBK-190 is required for the DSR-2000P
*6 The optional DSBK1803 is required for the DSR-1800P/1600P
DSR-1800P DSR-1600P
AC 100 V to 240 V, 50/60 Hz
100 W
5 °C to 40 °C (41 °F to 104 °F)
-20 °C to 60 °C (-4 °F to 140 °F)
Less than 80%
Less than 90%
28.221 mm/s
Shuttle mode: still to ±60 times normal speed
Digital slow mode: ±0.5 times normal speed
13 kg (28 lb 10 oz)
427 x 174 x 400 mm
(16 7/8 x 6 7/8 x 15 3/4 inches)
25 Hz to 5.0 MHz ±1.0 dB
25 Hz to 2.0 MHz + 1.0/-2.0 dB
More than 55 dB
Less than 2.0%
Less than 30 ns
More than 90 dB
Less than 0.05%
Y: 1.0 Vp-p, 75 Ω , sync negative
C: 0.3 Vp-p, 75 Ω (at burst level)
0.3 Vp-p, 75 Ω , sync negative
Video 1/2(super) BNC x 2
Composite, 1.0 Vp-p, 75 Ω , sync negative
R-Y: 0.7 Vp-p, 75 Ω (100%)
DIN 4-pin x 1
Y: 1.0 Vp-p, 75 Ω , sync negative C: 0.3 Vp-p, 75 Ω (at burst level)
Conforms to Serial Digital Interface (270 Mb/s), ITU-R BT.656
BNC x 1
Conforms to SDTI (270 Mb/s), SMPTE 305M/322M
IEEE1394-based
XLR 3-pin male x4
-6/-3/0/+4 dBu (selectable by menu)
-9 dBu, 47 kΩ ,
unbalanced (-18 dBFS)
-∞to -11 dBu, 8 Ω ,
unbalanced (-18 dBFS)
BNC x 2 75 Ω , unbalanced
0.5 Vp-p to 18 Vp-p, 3 kΩ , unbalanced
2.2 Vp-p, 75 Ω , unbalanced
RS-422A: D-sub 9-pin female x1
Video Control: D-sub 15-pin male x1
Control S (SIRCS): Stereo mini jack x1
AC Power Cord
Operating Instructions
Editing Recorders / Players
DSR-1500AP
70 W 60 W
6 kg (13 lb 3 oz)
210 x 130 x 420 mm
(8 3/8 x 5 1/8 x 16 5/8 inches)
25 Hz to 5.0 MHz +1.0/-1.5 dB
20 Hz to 20 kHz ±1.0 dB
20 Hz to 14.5 kHz ±1.0 dB
More than 87 dB
Less than 0.07%
— Composite, 1.0 Vp-p, 75 Ω ,
sync negative
— Composite, 1.0 Vp-p, 75 Ω , sync negative
— 1.0 Vp-p, 75 Ω , sync negative
— 0.7 Vp-p, 75 Ω (100 %)
— 0.7 Vp-p, 75 Ω (100 %)
— BNC x 2
— BNC x 1
Conforms to Serial Digital Interface
(270 Mb/s), ITU-RBT.656
— Conforms to SDTI (270 Mb/s),
SMPTE 305M/322M
— IEEE1394-based
— XLR 3-pin female x2
— -6/-3/0/+4 dBu,
high impedance
— BNC x 2
75 Ω , unbalanced
Video 1/2/3 (super) BNC x 3
B-Y: 0.7 Vp-p, 75 Ω (100%)
BNC x 2
BNC x 2
BNC x 2
XLR 3-pin male x2
RCA x1
-∞ to +1 dBu, 47 kΩ ,
unbalanced (-20 dBFS)
-∞to -13 dBu, 8 Ω ,
unbalanced (-20 dBFS)
RS-422A: D-sub 9-pin female x1
Control S (SIRCS): Stereo mini jack x1
*7 The optional DSBK1503 is required for the DSR-1500AP
*8 The optional DSBK-1601 is required for the DSR-1600P
*9 The optional DSBK-1602 is required for the DSR-1600P
—