Programming The Remote Control - Sony WEGA KV 32HS20 Operating Instructions Manual

Other Information

Programming the Remote Control

POWER
MUTING
VCR/DVD SAT/CABLE
TV
SLEEP
DVD MENU REC
2 3
1
4 5 6
7 8 9
CODE SET ENTER
0
FUNCTION
TV/VIDEO VCR/DVD SAT/CABLE TV
FREEZE
VOL CH
MENU
FAVORITES
RESET AV 1 2 3 DVD RM -Y183
50
The remote control is preset to operate Sony brand video equipment.
Sony
Equipment
Beta, ED Beta VCRs
8 mm VCR
VHS VCR
DVD Player
If you have video equipment other than Sony brand that you want to
control with the TV's remote control, use the following procedures to
program the remote control.
The equipment must have infrared (IR) remote capability in order to be used
with the remote control.
From the "Manufacturer's Codes" listed on page 52, select the three-
digit code number for the manufacturer's code for your equipment. If
more than one code number is listed, start with the number listed
first. Use the code number to complete the following procedure.
1
Move the slide switch to the desired equipment type.
2
Press CODE SET.
4
You must perform step 3 within 10 seconds of step 2, or you must start
again from step 2.
5
2
3
Press the white function button for the type of equipment you
3
want to control with the TV's remote control (VCR/DVD or
SAT/CABLE).
4
Enter the three-digit manufacturer's code number.
5
Press ENTER.
6
To check if the code number works, aim the TV's remote control
at the equipment and press the green POWER button that
1
corresponds with that equipment. If it responds, you are done. If
not, try using the other codes listed for that manufacturer.
Switch Position
on Remote Control
AV1
AV2
AV3
DVD
Programmable
Code Number
303
302
301
751