Table of Contents
Advertisement
Siemens Building Technologies
Cerberus Division
2.3
The connection board
The connection board has two connectors to insert the CPU and I/O board in.
All the UARTs, from 1 to 6, are accessible through screw connectors located on the
right side of the connection board. Only the TX, RX and GND signals are available.
UARTs 5 and 6, if the expansion board is installed, are accessible on the same con-
nector.
In the lower right corner of the connection board there is the power supply block with
two pins marked + and -. You must connect here the voltage source (10 to 30 V d.c.).
Expansion board
CPU board
Fig. 3 The connection board
2.4
The assembled gateway
The three components (the CPU board, the Expansion board, the Connection board)
can be assembled in two different ways.
The following table shows these configurations:
CPU board
GW-21.06
x
GW-21.04
x
Tab. 2
GND
RX6
TX6
GND
RX5
TX5
GND
RX4
TX4
GND
RX3
TX3
GND
RX2
TX2
GND
RX1
TX1
+
Vdc
-
Expansion board
Connection Board
x
x
x
5
E1481b
06.2000
Advertisement
Table of Contents
