Attach Cleaning Pad; Assemble Power Adapter; Install Safety Tether - Cleanmate S 5000 User Manual

3. Operating CC901
 Please sure there is a 13cm (5.1") clearance between the glass and obstacles in the room like curtains or furniture.
 CC901 can clean horizontally mounted glass but only when using the Direction Control Buttons on the Remote
Control.
 CC901 can clean glass mounted at an angle but may not operate normally; in such a case, a person should be in
the vicinity to assist should there be a problem.
 Do not use CC901 upside down.
 CC901 should only be used with CC901 Cleaning Solution. Using other cleaners significantly reduces CC901' s
performance and can damage the robot.
 Please refer to the manufacturer's care and cleaning instructions before using CC901 on glass with an uneven
surface, such as frosted, textured, patterned, or coated glass. Product Manufacturer cannot be responsible for
damage due to improper use on these surfaces.
3.2 Attach the Cleaning Pad
Turn CC901 over and attach the Cleaning Pad to the bottom of
CC901 smoothly. The whiteside of the Cleaning Pad attaches to the
Velcro,and the gray microfiber side faces out. Make surethe Cleaning
Pad does not cover the Edge Detection Sensors, front bumper
sensor and rear bumper sensors.
3.3 Assemble the Power Adapter
3.4 Install the Safety Tether
A
A: CC901 Power Cord
B
B: Power Adapter Power Cord C: Safety Pod D: Safety Tether
5
C D