Sony KP-53PS1K Instruction Manual page 26

NexTView
Using the Long Info menu
VIDEO TV
1
2
To set the timer
1 2 3
Push the joystick 4 or $ to highlight the
button repeatedly to "set the timer" or "cancel the timer". If you choose
4 5 6
to set the timer, the programme is marked with a clock symbol and a
7 8 9 message appears on the screen shortly before the programme is due
to start asking whether you wish to still view this programme.
0
To view the timer table
Push the joystick Z or z to highlight the
button repeatedly to switch on/off the timer table. This table shows the
programmes on which you have already set a timer. (You can set a timer
on up to 5 programmes).
PROGR
To record programmes
MENU
(only with Smartlink VCRs)
1
RM 892
2
S
3
4
With this menu screen, you can set timers or record selected
programmes.
Push 4 or $ to select a future programme in the programme list
column.
Press the OK button to display the Long Info menu on the TV
screen.
Connect your Smartlink VCR.
Push the joystick to Z or z to select
to download the information to your VCR.
To set up the VCR:
VPS/PDC
Push the joystick Z or z to select VPS/PDC then press the OK
button repeatedly to select On or Off. With this setting on you have
the guaranteed recording of the whole broadcast should there be a
change in the TV programme. This only works if the selected
channel broadcasts a VPS/PDC signal.
Speed
Push the joystick to $ to select Speed then press the OK button
repeatedly to select between SP for standardplay or LP for longplay.
With longplay you can record twice as much on a videotape.
The picture quality however may suffer.
VCR Setup
Push the joystick to $ to select VCR Setup then press the OK
button repeatedly to select which VCR you wish to programme,
namely VCR1 or VCR2.
Finally, push the joystick to z to select the
OK button to remove the menu from the TV screen.
icon then press the OK
icon then press the OK
then press the OK button
icon then press the
First nextTView/EPG-Providers in Europe
07 Tue
SWISS TXT TPS / RINGIER nexTView
12:38
Tue 07. 04 .98
Address Mapping
The position of the addresses in the
OSDA is shown in the following diagram.
The position values of the DPW are set
to '0'.
If other values are set, the complete
combination will be scrolled.
GB
Example:
if the DPWC is set to '63', the char-
This channel has been set for a timer
VPS/PDC On
Speed SP
Timer Prog VCR1
VPS/PDC On
SP
Speed
VCR1
VCR Setup
27
NexTView