Connecting An Aerial And A Vcr To The Tv; Switching On The Tv - Sony KD-32NX200E Instruction Manual

3

Connecting an aerial and a VCR to the TV

Connecting an aerial only
(SMARTLINK)
3 s 3
VCR
2
DVD
1
DIGITAL
OPTICAL OUTPUT
ANALOGUE
MODEM . . . 5V 200mA
R/D/D/D L/G/S/I
RF loopthrough
lead (supplied)
Connecting an aerial and a VCR
(SMARTLINK)
3 s 3
VCR
2
DVD
1
DIGITAL
OPTICAL OUTPUT
ANALOGUE
. . .
MODEM 5V 200mA
R/D/D/D L/G/S/I
Scart lead
(not supplied)
4

Switching on the TV

1.
2.
Existing
aerial lead
1.
2.
3.
4.
5.
6.
RF loopthrough
cable (supplied)
RF lead (not
supplied)
Note:
Your VCR sockets may not be labelled RF IN and RF OUT. If not,
please refer to your VCR instruction manual for guidance.
1.
2.
Note:
If the red indicator on the front of the TV is lit the TV is in standby
mode. Press the TV
the TV. Please be patient as the picture may take a few moments to
appear on screen.
Connect your existing aerial lead to the digital
socket marked on the rear of the TV as
shown.
Connect the supplied RF loopthrough cable from
the socket marked to the analogue socket
marked .
Connect your existing aerial lead to the digital
socket marked on the rear of the TV as shown.
Connect the supplied RF loopthrough cable from
the lower socket marked
IN socket on your VCR.
Connect a lead from the RF OUT socket on your
VCR to the analogue socket marked
Connect a fully wired scart lead from the
3 s 3 socket on the rear of the TV to the scart
socket on your VCR (refer to your VCR instruction
manual).
Connect the VCR to the mains socket and switch
on.
Insert a pre-recorded tape into the VCR and press
the 'PLAY' button. This enables the TV to locate and
store the video channel during the 'Automatically
tuning the TV' procedure.
Connect the TV plug to your mains socket
(220 - 240 V AC, 50 Hz).
Push in the on/off button (labelled
front of the TV.
/
button on the remote control to switch on
Getting started
on the TV to the RF
on the TV.
) on the
5