Download  Print this page

Connecting Two Rf Inputs; Cable Box Only - Sony KD-34XBR970 Operating Instructions Manual

Fd trinitron & wega: 34" hdtv 16x9 format.
Hide thumbs

Advertisement

Connecting Two RF
Inputs

Cable Box Only

Notes on Using This Connection
To Do This ...
Use the cable box
Set up the TV remote control
to operate the cable box
Activate the remote control to
operate the cable box
6
If you want to watch RF signals for both antenna (over-the-air) and
cable broadcast signals, you'll need to use an optional A-B switch for
RF inputs (not supplied), as shown below.
A/B
RF Switch
Cable
A
B
Antenna
Use the A-B selector to switch between the over-the-air signals and
the cable signals. Then set the
or
, as described on page 40.
On
Off
For best results, be sure to use an RF switch, as shown above, instead of a
simple splitter.
For best results, use this connection if:
Your cable company scrambles all channels, which requires you
to use a cable box.
You do not have a VCR. (If you have a VCR, see pages 8 and 9.)
With this connection you can:
Use the TV remote control to change channels coming through
the cable box to the TV's VHF/UHF jack. (You must first
program the remote control for your specific cable box.)
To connect the cable box
1
Connect the CATV cable to the cable box's input jack.
2
Use a coaxial cable to connect the cable box's output jack to the
TV's VHF/UHF jack.
CATV
Coaxial cable
cable
1
2
IN
OUT
Cable box
3
Run Auto Program, as described in "Setting Up the Channel List"
on page 20.
Do This ...
Tune the TV to the channel the cable box is set to (usually channel 3 or 4)
and then use the cable box to switch channels.
Program the remote control. See "Programming the Remote Control" on
page 24.
Press
SAT/CABLE
FUNCTION.
(Rear of TV)
VHF/UHF
setting in the Channel Settings to
Cable
TV
VHF/UHF

Advertisement

Table of Contents

   Also See for Sony KD-34XBR970

   Related Manuals for Sony KD-34XBR970

Comments to this Manuals

Symbols: 0
Latest comments: