Sony SPP-A2770 Operating Instructions Manual page 22

Step 6: Setting the day and time (continued)
5
Press Jog Dial.
6
Set the minute (00 to 59) by turning Jog Dial.
7
Press Jog Dial.
8
Select "AM" or "PM" by turning Jog Dial, and
then press Jog Dial.
You hear a long confirmation beep. Then the
phone starts counting time.
Notes
• Do not allow more than 60 seconds to elapse during the operation procedure.
• "PF" flashes on the message counter when the day and time is cleared due to
a power interruption, or when you connect the base unit to the AC outlet for
the first time.
• If the current day and time are not set, you will not hear a time stamp when
you play back recorded messages.
• When "ERROR " appears on the display and five short error beeps are heard
after Jog Dial is pressed in step 8, move the cordless handset closer to the
base unit, make sure the base unit* is not in use before you start the setting.
* If the system includes additional cordless handsets, it is necessary to stop
using them before you start the setting as well.
Tip
When you select "(GO BACK)", you can return to the previous set display by
pressing Jog Dial.
To check the current day and time
Press (DAY/TIME) on the base unit.
You hear the current day and time by voice guidance.
22 US
Getting Started
ENTER MIMUTE AND
PRESS JOG DIAL
11:00
NEW OLD MASSAGE RING OFF
ENTER MINUTE AND
PRESS JOG DIAL
11:01
NEW OLD MASSAGE RING OFF
SELECT AM/PM AND
PRESS JOG DIAL
11:01AMAM
NEW OLD MASSAGE RING OFF