3.3
Evaluation board setup and connection
Connect the evaluation boards as described below (See Fig. 3-4).
1.
Connect the NIJYO board to the CASTLE board, making sure that the EPSON logos on the two
boards face in the same direction.
2.
Set the DIP switches and jumper pin on the CASTLE board and NIJYO boards as shown in
Tables 3-1, 3-2, and 3-3.
3.
Use the provided USB cable to connect the battery to the CASTLE board (mini-USB connector).
4.
Connect your speaker to the voice output port on the NIJYO board.
S1V3034x Series Evaluation Kit Start Guide
(Rev. 1.00)
Table 3-1 CASTLE board DIP switch (SW1) settings
DIP switch
SW1-1
SW1-2
SW1-3
SW1-4
SW1-5
SW1-6
Table 3-2 CASTLE board jumper pin (JP1) settings
Jumper pin
JP1
Table 3-3 NIJYO board DIP switch (SW1) settings
DIP switch
SW1-1
SW1-2
SW1-3
SW1-4
SW1-5
SW1-6
Setting
OFF
OFF
OFF
ON
ON
OFF
Setting
1 - 3pin Short
2 - 4pin Short
Setting
ON
OFF
ON
ON
ON
OFF
EPSON
3. Operating Method
5