Troubleshooting; On-Screen Messages - Sony SDM-S73E Operating Instructions Manual

Troubleshooting

Before contacting technical support, refer to this section.

On-screen messages

If there is something wrong with the input signal, one of the
following messages appears on the screen. To solve the problem,
see "Trouble symptoms and remedies" on page 19.
If "OUT OF RANGE" appears on the screen
This indicates that the input signal is not supported by the
monitor's specifications. Check the following items.
For more information about on-screen messages, see "Trouble
symptoms and remedies" on page 19.
If "xxx.x kHz/xxx Hz" is displayed
This indicates that either the horizontal or vertical frequency
is not supported by the monitor's specifications.
The figures indicate the horizontal and vertical frequencies of
the current input signal.
SDM-S73E
I NFORMA T I ON
OUT OF RANGE
x x x . x k H z /
SDM-S74E
I NFORMA T I ON
OUT OF RANGE
I NPUT 1 DV I - D :
x x x . x k H z /
If "RESOLUTION > 1280 × 1024" is displayed
This indicates that the resolution is not supported by the
monitor's specifications (1280 × 1024 or less).
SDM-S73E
I NFORMA T I ON
OUT OF RANGE
RESOL UT I ON >
SDM-S74E
I NFORMA T I ON
OUT OF RANGE
I NPUT 1 : DV I - D
RESOL UT I ON >
18
x x x H z
x x x H z
1 8 0 X 1 . 2 0 2 4
1 8 0 X 1 2 0 2 4
If "NO INPUT SIGNAL" appears on the screen
This indicates that no signal is being input via the currently
selected connector.
On the SDM-S74E, when INPUT SENSING (page 15) is set to
AUTO ON, the monitor finds another input signal and changes
the input automatically.
SDM-S73E
I NFORMA T I ON
NO I NPUT S I GNA L
GO TO POWER SAVE
SDM-S74E
I NFORMA T I ON
NO I NPUT S I GNA L
I NPUT 1 DV I - D :
GO TO POWER SAVE
"GO TO POWER SAVE"
The monitor will enter the power saving mode after about 5
seconds from the time the message is displayed.
If "CABLE DISCONNECTED" appears on the
screen
This indicates that the video signal cable has been disconnected
from the currently selected connector.
On the SDM-S74E, when INPUT SENSING (page 15) is set to
AUTO ON, the monitor finds another input signal and changes
the input automatically.
SDM-S73E
I NFORMA T I ON
CAB L E D I SCONNECT ED
SDM-S74E
I NFORMA T I ON
CAB L E D I SCONNECT ED
I NPUT 1 DV I - D :