Function Button Setting - Sony LMD-2450MD Instructions For Use Manual

Sony computer monitor user manual
Hide thumbs Also See for LMD-2450MD:
Table of Contents

Advertisement

WAVE FORM
Sets the signal to display the waveform.
You can select from among Y, R, G and
B signals.
You can select the sync timing signal for
Y, R, G or B signal from H PERIOD or
V PERIOD.

FUNCTION BUTTON SETTING

USER CONFIGtFUNCTION BUTTON SETTING
F 1 B U T T O N :
F 2 B U T T O N :
F 3 B U T T O N :
F 4 B U T T O N :
Submenu
Setting
F1 BUTTON to F4
Assigns the function to the function
BUTTON
buttons of the front panel and turns the
function on or off.
You can assign the function from
among SCAN, ASPECT, EXT SYNC,
BLUE ONLY, MONO, H/V DELAY,
MULTI DISPLAY and APA.
Factory setting
• F1 button: EXT SYNC
• F2 button: SCAN
• F3 button: ASPECT
• F4 button: MULTI DISPLAY
About the function assigned to the
function button
SCAN
Press to change the scan size of the picture according to
the setting of "STANDARD" or "FULL+NATIVE"
selected in SCAN (page 24).
ASPECT
Press to set the aspect ratio of the picture, 4:3 or 16:9.
Note
The panel of the monitor is 16:10.
When the 16:9 signal is displayed, black bars appear in
the upper and lower positions of the display. This is not
a malfunction. (See "Scan mode image" on page 25.)
EXT SYNC (external sync)
Press to operate the unit on an external sync signal
through the EXT SYNC IN connector.
EXT SYNC works when the component/RGB signals
are input.
BLUE ONLY
Press the assigned button to eliminate the red and green
signals. Only blue signal is displayed as an apparent
monochrome picture on the screen. This facilitates
26
Adjustment Using the Menus
xxxx
xxxx
xxxx
xxxx
"chroma" and "phase" adjustments and observation of
VCR noise.
MONO
Press the assigned button to display a monochrome
picture. When the buttons is pressed again, the monitor
switches automatically to color mode.
H/V DELAY
Press to observe the horizontal and vertical sync signals
at the same time.
MULTI DISPLAY
Press the assigned button to display the multi display.
Set the multi display setting in the MULTI DISPLAY
SETTING menu (see page 25).
APA (Auto Pixel Alignment)
Press to adjust the picture automatically to maximum
clarity for the signal input to the HD15 input connector.
For finer according to the input signal, see "DOT
PHASE" on page 23.
When the menu screen is displayed, the APA does not
function.
Note
If the APA operation does not finish correctly depending
on the input signal, adjust DOT PHASE (page 23).
COMPUTER DETECT
USER CONFIGtCOMPUTER DETECT
DV I :
H D 1 5 :
Submenu
Setting
COMPUTER
The appropriate preset memory is set for
DETECT
the signal from DVI and HD15 input
connector. Select "PRESET1" for the
standard PC signal. Select "PRESET2",
"PRESET3", "PRESET4", "PRESET5"
or "PRESET6" when the PC signal is not
standard (on page 33).
The preset memory is set for each input
connector of DVI and HD15.
xxxxx
xxxxx

Advertisement

Table of Contents
loading

Table of Contents