Submenu
Setting
GAMMA
Selects the appropriate gamma
mode from between two settings
(“2.2”, “DICOM”).
When “2.2” is selected, the setting
is roughly same as the gamma
mode of the CRT.
FORMAT DISPLAY
Selects the display mode of the
signal format and scan mode.
• ON: The format is always
displayed.
• OFF: The display is hidden.
• AUTO: The format is displayed
for about 10 seconds when
the input of the signal starts.
LANGUAGE
Selects the menu or message
language from among seven
languages.
• ENGLISH: English
• FRANÇAIS: French
• DEUTSCH: German
• ESPAÑOL: Spanish
• ITALIANO: Italian
•
: Japanese
•
: Chinese
POWER SAVING
Sets the power saving mode on or
off. When you set to ON, the
monitor goes into power saving
mode if no signal is input for about
one minute.
PICTURE DELAY MIN
Selects to set the delay by the
picture processing to the minimum
level when the interlace signal is
input.
• 0: Mode for giving precedence
to the picture quality. It takes
longer than “1” or “2” for
processing the picture. “0” is
the factory setting.
• 1: The processing time is short
and this is a mode suitable for an
animation. Even when the
picture is constructed by one
field such as the proxy picture of
XDCAM, a smooth picture is
displayed.
• 2: The processing time is
shorter. As the line flicker is
displayed in this mode, it is
available for checking the line
flicker of the telop work and so
on.
Page 24