Key Inhibit Menu - Sony LMD-2050W Operating Instructions Manual

Submenu
PARALLEL REMOTE
30
Adjustment Using the Menus
Setting
Selects the PARALLEL REMOTE
connector pins for which you want
to change the function.
You can assign various functions to
1 to 4 pins and 6 to 8 pins. The
following lists the functions you
can assign to the pins.
• – – – ("– – –": No function is
assigned.)
• COMPOSITE
• Y/C
• RGB
• COMPONENT
• DVI
• HD15
• OPTION A-1
• OPTION A-2
• OPTION B-1
• OPTION B-2
• OVERSCAN
• FULL
• NORMAL
• NATIVE
• 4:3
• 16:9
• TALLY R
• TALLY G
• EXT SYNC
• BLUE ONLY
• MONO
• H/V DELAY
• 16:9 MARKER
• 15:9 MARKER
• 14:9 MARKER
• 13:9 MARKER
• 1.85:1 MARKER
• 2.35:1 MARKER
• 1.85:1 & 4:3 MARKER
• 4:3 MARKER
• CENTER MARKER
• SAFE AREA 80 %
• SAFE AREA 85 %
• SAFE AREA 88 %
• SAFE AREA 90 %
• SAFE AREA 93 %
• MARKER MAT HALF
• MARKER MAT BLACK
Notes
• If you use the PARALLEL
REMOTE function, you need to
connect cables. For more details,
see page 33.
• Set MARKER ENABLE
(page 26) to ON to control the
aspect marker, center marker or
safe area marker.
Submenu Setting
SERIAL REMOTE Selects the mode to be used.
• OFF: SERIAL REMOTE does
not function.
• RS-232C: The monitor is
controlled by the command of
RS-232C.
• ETHERNET: The monitor is
controlled by the command of
Ethernet.
• BKM-15R: Sets BKM-15R.
MONITOR Sets the monitor setting.
CONTROLLER Sets the address of the remote
controller.
CONNECTION Sets the connection of the monitor
and the controller.

KEY INHIBIT menu

KEY INHIBIT
K E Y I N H I B I T :
MONITOR ID: Sets the ID
of the monitor.
GROUP ID: Sets the group
ID of the monitor.
IP ADDRESS: Sets the IP
address.
SUBNET MASK: Sets the
subnet mask.
(255.255.255.000)
DEFAULT GATEWAY:
Sets the default gateway on
or off.
ADDRESS: Sets the default
gateway.
CANCEL: Selects to cancel
the setting.
CONFIRM: Selects to save
the setting.
IP ADDRESS: Sets the IP
address.
SUBNET MASK: Sets the
subnet mask.
(255.255.255.000)
DEFAULT GATEWAY:
Sets the default gateway on
or off.
ADDRESS: Sets the default
gateway.
CANCEL: Selects to cancel
the setting.
CONFIRM: Selects to save
the setting.
PEER TO PEER: for one
to one connection
LAN: for connection via a
network
xx