Electrolux EVEP916 Installation & User Manual page 53

INSTALLATION OF EFE914, EFEP916 & EFEP956
Installing splashback
Fit splashback to rear of hob with three screws provided.
Installing the anti-tilt brackets
To ensure cooker stability, the anti-tilt brackets must be
installed.
There are left and right engagement slots for the anti-tilt
bracket at the bottom rear of the appliance.
(CONTINUED)
The following steps must be followed to ensure the correct
installation of anti-tilt brackets and the stability of the
appliances.
CAUTION
It is not recommended to push and pull the appliance on
uneven or rough surface. Use other means to maneuver
the appliance if necessary.
1 Carefully push the appliance into the cabinet
cavity until the back of the oven is flush against
the back wall.
2 Use non-permanent methods to mark a line on the
wall along the top surface of the splashback. This
line is used as a reference line to locate the correct
location of where the anti-tilt brackets need to be
installed.
3 After the reference line is marked, pull the appliance
out of the cabinet cavity to install the anti-tilt
brackets.
Anti-tilt bracket
installation
reference line
53